Safety Precautions

Please be safe

● If you are inexperienced in electrical wiring or light fixture installation, always contact a licensed electrician.

● ALWAYS shut off power to the circuit before attempting removal of an existing fixture or fixture installation. NEVER attempt to replace a fixture while the wire is "hot."

● Be aware that even after the circuit has been switched off, there is a chance there may be live (hot) wires in the ceiling box. To ensure that all of the wires are off, use a circuit tester (you can get these at any hardware store).

● Never exceed the maximum wattage of the fixture.

● Be sure that the junction box you are using can support the weight of the ceiling fan or fixture you are installing. If installing a heavy chandelier or ceiling fan, the hardware should always be mounted to the ceiling joists.

● Always have a partner to assist you in mounting the fixture. Typically, one person needs to hold the fixture up while the other wires it.

● Be sure to read the package instructions thoroughly before attempting assembly.

● If installing a ceiling fan, be sure that the "safety" wire is in place.

● Always follow your local codes concerning light fixture placement and installation.

Before Installation

T8 Tube Diagram

● Check your state and local codes before starting any project!

● When you receive your package, open it immediately to ensure all of the parts are included in the box and intact. The instruction manual should include a diagram of all of the parts included with the fixture.

● If there are fragile parts (e.g. glass globes), keep them in a safe place until installation - away from kids, pets, potential falls and so on.

● Check the existing junction box to be sure it can hold the weight of the new fixture. If in doubt, replace the junction box with one that is approved for the weight of your new fixture. Ceiling fans and heavy lights should always be supported by the ceiling joists.

What you should have before doing an installation

If you are installing ceiling fixtures, you will need a safe and stable ladder.  Resist the urge to use a chair or other substitute piece of furniture.

Gloves not only protect your hands from heat, but in the event a bulb breaks upon disassemble, you will want your hands protected.  NEVER handle a CFL bulb without proper equipment.

Wire nuts to secure your freshly cut wires together.

Wire cutters will allow you to not only make clean cuts and strips, but also are excellent at connecting wires together by crimping butt connectors.

Always wear safety glasses, especially when looking up at your work.  Beyond broken glass, in many cases you will encounter dust, debris, or insulation, none of which you want in you eyes.  Plus, you look way cooler with them on. Go eyes!

Finally, your Brain.  Use it.  It is the most important too you are bringing to the occasion.  Also, don't rush.

 If you need help, stop what you are doing and call (435) 272-1813 EX. 3000

© Copyright, 2013 LighWise, Inc. | All rights reserved.